W24S-45 profile bending machine is the second smallest machine in the W24S series of our company’s products. It also does not have the function of bending H-beam; of course, other profiles such as: angle, pipe,square tube, channel, I-beam, flat & square bar and tees It can be easily bent. They are more used to bend flanges (Here you can also call it a flange bending machine) in some factories in China.
The standard configuration is equipped with 8 sets of hydraulic components to ensure accurate bending of profiles.
Like other BIT series section bending machines, the W24S-45 profile bending machine can provide the best results for the bending of special and standard profiles as well as low carbon steel, stainless steel, aluminum, bronze, copper and other steel alloys.
In the introduction of the W24S-250 machine, we showed a picture of the W24S-45 bending stainless steel channel.
Reinforced support plates are also hidden inside the fuselage to ensure the stability of the fuselage during bending.
Some small details can better understand our craftsmanship.
|Min.bending DIA(mm):||Φ700||Min.bending DIA(mm):||Φ600|
|Min.bending DIA(mm):||Φ600||Min.bending DIA(mm):||Φ1000|
|Min.bending DIA(mm):||Φ1500||Min.bending DIA(mm):||Φ1200|
|Min.bending DIA(mm):||Φ2000||Min.bending DIA(mm):||Φ600|
|Min.bending DIA(mm):||Φ600||Min.bending DIA(mm):||Φ800|
|Min.bending DIA(mm):||Φ600||Min.bending DIA(mm)|
|Sectional modulus cm3:||16-45||Bending speed:||6 Meters/Minute|
|Material yield limit(Mpa):||250||Motor power (KW):||11|
W24S-45 Profile Bending Machine Photo
W24S-45 Profile Bending Machine Feature
W24S-45 Section Bending Machine ( Profile bending machine ) bed as a steel plate welding structure, and annealing treatment to eliminate internal stress.
The machine has sufficient strength and stiffness to satisfy the bending of the profile in the range of the machine.
W24S-45 Section Bending Machine is mainly composed of fuselage part, side roll part, idler part, transmission part, electrical part and hydraulic system, mould and so on.
Profile bending machine has the bending function of the profile, three working rollers are mainly drive rollers, through the hydraulic motor, gear to achieve, the two lower roll for hydraulic transmission.
The two rollers can be around the fixed rotary center to do arc movements, work rolls on both sides of the roll and Correction Guide roll device, to ensure that asymmetrical section (such as angle steel) profile roll quality.