SOME KNOWLEDGE ABOUT THE ROUNDNESS TOLERANCE OF STEEL PIPE & TUBE

This is a description for the hero section. Synergestic actionables. Organic growth deep dive but circle back or but what’s the real problem we’re trying to solve here?

Pipes and tubes are usually measured by the outside diameter dimension – or OD. One might think that a 2.0 inch OD tube would measure 2.0 inches and a 6.5 inch OD tube would measure 6.5 inches. However, machines today cannot hold dimensions precisely to the nominal value, and because of that there must be acceptable degrees of variations. In other words, every dimension on a blueprint is subject to variations from the nominal value and so is “roundness”. But “out of roundess” measurement can be contained.

Tubes, pipes or solids will have a range of values that would be acceptable and considered as ‘x’ nominal OD. Roundness tolerance (+/- 0.01 inch) would mean the difference between major OD and the minor OD throughout the profile should not be greater or less than 0.01 inches.

When bending round profiles to a certain radius, the greater the OD to bend radius, the higher ovality should be expected.

American Society of Mechanical Engineers ASME states the following, “on section B31.1-2001 104.2 Curved Segments of Pipe (B) For ferrous material, when the radius of a bend is 5 nominal pipe diameters or greater, and the nominal wall thickness of the pipe is schedule 40 or thicker, the difference between maximum and minimum diameters shall not exceed 8% of average measured outside diameter of the pipe before bending.”

As a guideline, we consider 5% ovality as an acceptable measurement. That said, the ovality should always be discussed and determined by the end user prior to rolling. The table below can be used as reference for expected ovality when bending hollow pipe or tube.

Angle,Beam,Tube,Channel,Pipe,Bar,Tee,Steel Section Bending Tolerances

Important link

List of our products:profile bending machine
Must know section bending information:practical guide to the section bending of various metal profiles

SEARCH

w24s profile bending machine
W24 SERIES

Driven by hydraulic motor (up to 9), powerful bending ability.Standard machine section modulus: 16CM3-600CM3. Can bend various types of materials into an arc or a circle.It can bend copper, carbon steel, stainless steel and aluminum profiles.
Angle, channel, beam, flat bar, round & square bar,pipe,square tube.

aluminum profile bending machine
B CNC SERIES

CNC control. Accuracy is as high as ≤0.01mm. 
Can be bent in various shapes (3-D graphics, C-shaped, U-shaped, full circle, ellipse, multiple radii combination shapes, etc.)
Suitable for bending of aluminum profiles for automobiles, doors and windows

section bender
section bender
MS SERIES

Small section bender (section bending machine), with manual and semi-hydraulic drives, can bend profiles other than beam.
Cheap price, first choice for small factories

profile bending

Select the items you want to follow based on the subtitles below.
Next, you will find relevant information.